V-Tech CAT5 System Technical Guide - Manual (Page 113)

Page 113 K5 System Technical Guide
• Extended Monitor Configuration
Maximum 3 monitors can be set in one apartment. One of them is Master and the other 2 slave
monitors. Now assume that we want to add slave monitors to the A block 0021 monitor, right click
on A Block-0021 ->Select Extend Monitor Config on the pop-up window ->Config just like the
following picture-> Click Save button to finish. -> Software will check if the monitors are online
automatically. Note that only 2 extended monitors are valid in the system. Refer to latter chapters
about how to activate the extended monitors.
We can configure other blocks with the same method.
5.3.6§Default§project§parameters
The Default project parameters can apply to all the blocks(C5-IPC ) in the system. And each of the
C5-IPC can choose to run under the default project parameters or its own parameters shown in
later chapter. By right click on the Project name, we can get to the menu for default general pa-
rameters. And we will go through 4 parameters on this menu: