EVS IPDirector Version 6.0 - November 2012 Part 6 User's Manual - Manual (Page 49)

To do so, proceed as follows:
1. Assign a player to the Playlist Panel if yopu want to load the playlist.
2. Type either
◦ the playlist name in the Playlist Name field. If the playlist name entered by the
operator is found several times in the database, the last playlist created with that
name in the database is considered.
OR
◦ the LSM ID in the LSM ID field.
3. Press ENTER.
If a player has been assigned, the playlist will then be loaded on the IN point of the first
element.
If another playlist had previously been loaded, this latter is replaced by the new one on the
Playlist Panel.
Cuing up a Playlist or a Playlist Element to the Player
Channel
How to Cue up a Playlist
The Recue function re-loads the playlist on the first frame of the first element.
When a playlist is loaded on a player channel or the Software Player associated to a
Playlist Panel, loading an element type (clip, train, growing clip) on the same channel will
unload the playlist from the channel. However, it is still possible to load it again on the
associated player.
It is possible to recue the playlist in one of the following ways:
• Double-click the first element of the playlist in the Playlist Panel
OR
• Use the Recue function:
Operation User Interface Button Keyboard Shortcut
Recue
How to Cue a Playlist Element
To cue up one particular element of the playlist:
• double-click it on the Playlist Panel, if the Disable Double-Click on Playlist option
has not been selected under Settings > Playlist > General
• Use one of the ShuttlePRO keys:
IPDirector - Version 6.00 - User Manual - Playlist Panel
1. Playlist Panel 39