EVS IPDirector Version 6.0 - November 2012 Part 6 User's Manual - Manual (Page 150)

# - GPI Number
This corresponds to the GPI number in server tag:
• From 1 to 4 if TTL GPIs are set as input GPIs in Tools > Settings > Input GPIs
• From 1 to 8 if TTL GPIs are set as output GPIs in Tools > Settings > Output GPIs
Refer to Settings > GPI Settings in part 1 of the manual.
Type
This corresponds to the type of signal in server tag that the GPI key will have to send to
the third device:
Trigger Mode Description
Pulse Rising Edge The GPI signal will be a rising edge pulse.
Pulse Falling Edge The GPI signal will be a falling edge pulse.
Level High The output level is set to high.
Level Low The output level is set to low.
Pulse Duration
When a "Pulse" signal has been defined, a pulse duration needs to be specified as well.
This value may range from 00s01 to 59s29 in NTSC and from 00s01 to 59s24 in PAL.
Link to
Determines the position, in the playlist element, the GPI will be linked to.
Possible options are:
"Link to" option Description
Current position
(default value) GPI macro command will be linked to the current position, i.e. the
timecode corresponding to the use of the macro command.
Mark IN GPI macro command will be linked to the IN point of the element.
Mark OUT GPI macro command will be linked to the OUT point of the
element.
140 1. Playlist Panel
EVS Broadcast Equipment S.A. - November 2012 Issue 6.00.B