EVS IPDirector Version 6.0 - November 2012 Part 6 User's Manual - Manual (Page 39)

1.3.7. Channel Mode for Playout with Transition
Effects
Introduction
To be able to play the transition effects of a playlist on a single player channel, this
channel must support the "Mix on one channel" functionality. This can easily be checked
as the information is displayed in the title bar of the Playlist Panel the channel has been
assigned to.
• Channel not supporting "Mix on one channel" and involved in no association
(previously called 1PGM):
• Channel supporting "Mix on one channel":
If the "Mix on one channel" functionality is not supported or enabled, two player channels
must be used to be able to play the loaded item with transitions effects. These channels
must be set to PGM/PRV mode.
Limitations for the Mix on One Channel Functionality
A player channel will not support the "Mix on one channel" functionality in one of the
following cases:
• It is on a COHX board on the EVS video server
• It is a 1080p channel
• It is a 3D channel
• It is a 3G input
• It is on a V3X board on the EVS video server but the "Mix on one channel" parameter
is set to no.
Channel Modes
1PGM Mode
When the Playlist Panel is assigned a player channel supporting the "Mix on one channel"
functionality, a playlist can be loaded on that channel and played out with its transition
effects.
When the 1PGM mode is selected and a playlist is loaded on a player channel which does
not support the "Mix on one channel" functionality, the playlist will be played in Cut mode
on only 1 output.
IPDirector - Version 6.00 - User Manual - Playlist Panel
1. Playlist Panel 29