ZyXEL Communications Internet Security Gateway ZyWALL 2 Series - Manual (Page 375)

ZyWALL 2 Series User’s Guide
WAN and Dial Backup Setup 23-9
23.7 Editing TCP/IP Options
Move the cursor to the Edit IP field in menu 11.1, then press [SPACE BAR] to select Yes. Press [ENTER]
to open Menu 11.3 - Remote Node Network Layer Options.
Figure 23-7 Menu 11.3: Remote Node Network Layer Options
The following table describes the fields in this menu.
Table 23-6 Menu 11.3: Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
Rem IP
Address Leave this field set to 0.0.0.0 to have the ISP or other remote router
dynamically (automatically) send its IP address if you do not know it. Enter
the remote gateway’s IP address here if you know it (static). 0.0.0.0
(default)
Rem Subnet
Mask Leave this field set to 0.0.0.0 to have the ISP or other remote router
dynamically send its subnet mask if you do not know it. Enter the remote
gateway’s subnet mask here if you know it (static). 0.0.0.0
(default)
My WAN
Addr Leave the field set to 0.0.0.0 to have the ISP or other remote router
dynamically (automatically) assign your WAN IP address if you do not
know it. Enter your WAN IP address here if you know it (static).
This is the address assigned to your local ZyWALL, not the remote router.
0.0.0.0
(default)
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Network Address Translation= SUA Only
Metric= 15
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL: