ZyXEL Communications Internet Security Gateway ZyWALL 2 Series - Manual (Page 368)

ZyWALL 2 Series User’s Guide
23-2 WAN and Dial Backup Setup
Table 23-1 MAC Address Cloning in WAN Setup
FIELD DESCRIPTION EXAMPLE
IP Address This field is applicable only if you choose the IP address attached on
LAN method in the Assigned By field. Enter the IP address of the
computer on the LAN whose MAC you are cloning.
192.168.1.35
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
23.2 Dial Backup
The Dial Backup port can be used in reserve, as a traditional dial-up connection should the broadband
connection to the WAN port fail. To set up the auxiliary port (Dial Backup) for use in the event that the
regular WAN connection is dropped, first make sure you have set up the switch and port connection (see the
Quick Start Guide), then configure
1. Menu 2 - WAN Setup,
2. Menu 2.1 - Advanced WAN Setup and
3. Menu 11.1 - Remote Node Profile (Backup ISP) as shown next
Refer also to the traffic redirect section for information on an alternate backup WAN connection.
23.3 Configuring Dial Backup in Menu 2
From the main menu, enter 2 to open menu 2.
Figure 23-2 Menu 2: Dial Backup Setup
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Dial-Backup:
Active= No
Phone Number=
Port Speed= 9600
AT Command String:
Init=
Edit Advanced Setup= No
Press ENTER to Confirm or ESC to Cancel: