Nortel Networks Sun Fire V100 User Manual
Page 53
MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
53
Copyright © 2006 Nortel Networks
If you selected E for External time source, you will be prompted
as follows: How many external clock sources would
you like to reference [1]?
Enter 1.
6
You will see the following message: You have chosen to
configure NTP as follows:
Type of server: Management
Using external Time Source(s):
NTP SOURCE (Accounting IP address):
Is the above configuration correct (y/n)
Enter Y to accept or N to change.
7
You will see the following statement:
”You are now configuring IPMP (Multipathing)"
”Please have the MgmtSvr/AcctMgr Server
Physical IP addresses and the Machine Logical IP
address ready. Have 6 IP addresses that can be
used as ping buddies."
8
Press the Enter key to continue.
9
You will see the following message:
IP multipathing uses a failover timeout to
determine how long to wait before failing over
to the other interface. The value MUST be
numeric only! The default value is
1000mSec.
Press Enter to accept default value, or type in your
preferred setting and Enter.
10
Enter the primary machine physical IP address for the dmfe0
interface:
[Enter]
Example: 192.168.14.12
11
Enter the secondary machine physical IP address for the dmfe1
interface
[Enter]
Example: 192.168.14.13
12
Enter the
that are the ping targets.
Note: Do not enter the IP address of the server you are
working on.
IP Multipathing needs a set of reliable hosts to ping against.
Select a set of three IP addresses in this subnet that belong to