Nortel Networks Sun Fire V100 - Manual (Page 167)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
167 Copyright © 2006 Nortel Networks
The administrators will enter data into the remainder of the tabs
as appropriate for their specific situations.
3 After all of the configuration tabs are filled, click on the Apply
button. You can cancel the configuration at any time by clicking
on the Cancel button.
Procedure 47 Adding endpoints
At the System Management Console,
1 To add an endpoint from the file tree, navigate to and select the
Endpoints tab.
2 Lock the service by right clicking on it and selecting Lock from
the shortcut menu.
3 Right click again and select Modify from the shortcut menu.
4 Fill in the fields as necessary for each endpoint you need to add.
5 Click on the Apply button or cancel.
For the following procedures, use the Provisioning Client GUI.
Procedure 48 Adding the gateway (H.323 endpoint) as a valid SIP
user
At the Provisioning Client,
1 Ensure that the H.323 Endpoint is fully configured.
See the Provisioning Client User Guide (NN42020-105) for
more complete information on using the SIP Provisioning Client
for setting up and routing to gateways. The number of H.323
Gatekeepers deployed requires an equal number of routes to be
set up.
2 Add the gateway (H.323 Endpoint) as a valid SIP user under
Domains->Domain name->Users->Add user. This is required for
RAS to work properly. Do not configure any aliases for the H.323
endpoints.
3 Add a telephony route.
4 Add a routelist.
5 Configure the gateway in the following order:
• domain of the H.323 endpoint
• address of the MCS 5100 H.323 Gatekeeper
• H.323 id, to the gateway host. The h323_endpoint specifies
the H323-id that was configured on the MCS 5100 H.323