Nortel Networks Sun Fire V100 - Manual (Page 160)

NN10287-301 MCS 5100 3.5 Standard 5.0 December 2006
160 Copyright © 2006 Nortel Networks
Logical IP Address of each server. If running
simplex, provide the same address twice.”
2 Press Enter to continue.
3 You will see the following message: "Enter the machine
logical IP address of the management server."
Enter the server>[Enter]
Example : 192.168.14.11
4 You will see the following message: "Enter the machine
logical IP address of the accounting server."
Enter the server>[Enter]
Example : 192.168.14.11
5 You will see the following message:
You have chosen to configure NTP as follows:
Type of server: Application
NTP SOURCE (Management IP address): logical IP address>
Type of server: Application
NTP SOURCE (Accounting IP address): logical IP address>
Is the above configuration correct (y/n):
Press Y to accept or N to change.
Wait until you see the following message:
You are now configuring IPMP (Multipathing).
Please have the Application Servers (Appsvr,
IPCM, WebSvr, WebClientMgr) Physical IP
addresses and the Machine Logical IP address
ready. Have 6 IP addresses that can be used as
ping buddies. Recommendations for ping buddies
are provided.
6 Press Enter to continue.
7 When you see the IP multipathing configuration for Sun Solaris
information appear, press Enter to accept it or type in a
preferred setting. The default failover timeout is set to
1000mSec.
8 Enter the primary machine physical IP address for the dmfe0
interface: interface of the physical server you are
installing> [Enter]
Example: 192.168.14.12