Nortel Networks Sun Fire V100 - Manual (Page 38)

NN10287-301 MCS 5100 3.5 Standard 5.0 December 2006
38 Copyright © 2006 Nortel Networks
7 Enter your password: system [Enter]
8 Define server ip address
[Enter]
9 Define server ip subnet mask mask> [Enter]
10 Define server ip primary gateway address primary gateway> [Enter]
11 Define port: telnet newline
filtering cr [Enter]Note: Type a range [1-18] for every port the Sun Fire V100
server is connected to.12Define port for use with SMDI: Define port 19 telnet newline
filtering noneNote: You can verify the ports with the command:show ports
1-19 telnet chara [Enter]13Save your changes.14Log out.Note: Using the command define saves the configuration.15To kill a session on a port, type: logout port 12 [Enter]Procedure 9 Connecting a server to the MRV LX terminal serverAt the management pc,1Connect a cat-5 Ethernet cable from the management PC to the
layer-2 switch.2Launch PuTTY.Note: Refer to the customer-specific information datasheet to
enter the MRV LX terminal server IP address and the port
number.ATTENTIONThe procedures in this document assume that you are using
PuTTY. It is suggested that you download from the web, PuTTY
VT 100 Emulator, a shareware configurator tool to set up
sessions.Download PuTTY from
http://www.chiark.greenend.org.uk/~sgtatham/putty/ Pages: 1 … 36 37 38 39 40 … 192 wrong Brand wrong Model non readable See also other documents in the category Nortel Networks Computers: NN43001-106 (576 pages) NTRN10AN (342 pages) NN43001-314 (418 pages) CALLPILOT P0605618 (80 pages) NN43001-122 (56 pages) NN42020-123 (58 pages) NN43001-321 (110 pages) NN10265-111 (118 pages) Broadcast Server (84 pages) NN43001-100 (70 pages) NN43001-301 (306 pages) SRG 50 NN43001-307 (222 pages) NN43001-121 (304 pages) 1000M (474 pages) 1000S (46 pages) NN44470-100 (63 pages) CALLPILOT 555-7101-226 (72 pages) Sun Fire V210 (RoHS) (176 pages) NN43001-563 (490 pages) Sitemap
Note: Type a range [1-18] for every port the Sun Fire V100
server is connected to.
12 Define port for use with SMDI: Define port 19 telnet newline
filtering none
Note: You can verify the ports with the command:show ports
1-19 telnet chara [Enter]
13 Save your changes.
14 Log out.
Note: Using the command define saves the configuration.
15 To kill a session on a port, type: logout port 12 [Enter]
Procedure 9 Connecting a server to the MRV LX terminal server
At the management pc,
1 Connect a cat-5 Ethernet cable from the management PC to the
layer-2 switch.
2 Launch PuTTY.
Note: Refer to the customer-specific information datasheet to
enter the MRV LX terminal server IP address and the port
number.
ATTENTION
The procedures in this document assume that you are using
PuTTY. It is suggested that you download from the web, PuTTY
VT 100 Emulator, a shareware configurator tool to set up
sessions.
Download PuTTY from
http://www.chiark.greenend.org.uk/~sgtatham/putty/