Nortel Networks Sun Fire V100 - Manual (Page 159)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
Copyright © 2006 Nortel Networks
Appendix A Installing the H.323
Gatekeeper
Installing the server for the H.323 Gatekeeper
Install Disks 1-3 as shown in Installing Disks 1 to 3 on V100 servers on
page 41 . Use the installation procedure in this chapter for installing Disk
4.
Follow the procedure for installing Disk 5 in Installing Disk 5 (all servers)
on page 61 . Refer to the remainder of this document for additional
installation information.
Approximate time estimate = 30 minutes
Procedure 44 Installing CD4
At the management pc,
1 Place CD4 in the CD-ROM drive and press Enter to continue.
WAIT until you see the following statement appear:
”You are now configuring the NTP time source for
this server. The servers which run the
Management and Accounting service will be the
source. You will need to provide the Machine
ATTENTION
Use these same procedures for each gatekeeper you install.
ATTENTION
Make sure you refer to your customer-specific information to
correctly enter the hostname, IP addresses, subnet masks, and
so on.