Siemens syngo CT 2005C - Manual (Page 248)

248
syngo 3D
Region Growing
Normally in the first step you will generate one or more
“objects“ from the volume data set originally loaded in
3D. By specifying a limited voxel value range you
extract only a section of the voxels from the original
data set. In this way, you generate an object in the
result segment.
Instead of extracting globally from the entire volume
data set, you can also proceed “slice by slice“ (in 3D
blocks) using the Slab Editor.
You can also set Seed Points in the original data set,
thus limiting the creation of an object to defined
regions which are also connected to one another in the
specified voxel area.
Object Punching
C2-025.630.01.01.02_APPLICATIONGUIDE_SPIRIT.book Page 248 Friday, April 8, 2005 9:55 AM