Motorola CPCI-6115 - Manual (Page 95)

IDE CompactFlash Connector Transition Module Preparation and Installation
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D) 93
5.5.1 IDE CompactFlash Connector
One 50-pin Type II CompactFlash card header connector located on both standard and MXP
versions of the CPCI-6115-MCPTM transition module provides the IDE interface to one
CompactFlash plug-in module. This CompactFlash interface is connected to the primary IDE
channel. The pin assignments for these connectors are as follows:
5.5.2 PMC I/O Module Connectors
There are two pairs of 64-pin surface mount connectors on both the standard and MXP version
of the CPCI-6115-MCPTM to provide an interface for two optional add-on PMC I/O modules.
Each module has an identical PMC I/O connector and a unique Host I/O connector. All serial
port signals are at TTL levels. The pin assignments are as follows:
Table 5-3 CompactFlash IDE Connector Pin Assignments, J1
Pin J1 Pin
1 GND NO CONNECT 26
2 DD3 DD11 27
3 DD4 DD12 28
4 DD5 DD13 29
5 DD6 DD14 30
6 DD7 DD15 31
7 CS1FX1_L CS3FX1_L 32
8 GND NO CONNECT 33
9 GND DIOR_L 34
10 GND DIOW_L 35
11 GND +5 V 36
12 GND INTRQ1 37
13 +5 V +5 V 38
14 GND MASTER/SLAVE 39
15 GND NO CONNECT 40
16 GND DRESET_L 41
17 GND DIORDY 42
18 DA2 NO CONNECT 43
19 DA1 +5 V 44
20 DA0 DASP 45
21 DD0 PDIAG 46
22 DD1 DD8 47
23 DD2 DD9 48
24 NO CONNECT DD10 49
25 NO CONNECT GND 50