Motorola CPCI-6115 - Manual (Page 39)

Setting Switches and Jumpers Hardware Preparation and Installation
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D) 37
2.5.2 Setting Switches and Jumpers
Figure 2-2 on page 35 illustrates the placement of the switches, jumper headers, connectors
and LED indicators on the CPCI-6115. Use this figure to help identify the approximate location
of the jumpers on the CPCI-6115. There are seven manually configured headers on the
baseboard. They are described in the following table:
Table 2-5 CPCI-6115 Jumper Map
Reference Function Comment
J6 Bus Mode Select
Header Jumper pins 1-2 for 60x mode
Jumper pins 2-3 for MPX mode
J9 Stand-Alone Operation
Header Jumper pins 1-2 for Stand-Alone operation (no CPCI bus)
J10 Flash Boot Bank Select
Header No jumper or jumper pins 1-2 for Bank A (32 MB)
Jumper pins 2-3 for Bank B (8 MB)
J15 +/-12 V Present Header Jumper pins 1-2 allows board operation without +/- 12 V
power
J20 Safe Start ENV Header No jumper or jumper pins 1-2 for normal ENV settings
Jumper pins 2-3 for safe ENV settings
J25 SROM Initialization
Enable Header Jumper pins 1-2 to enable SROM init
No jumper or jumper pins 2-3 to disable SROM init
J99 Flash Bank A Write
Protect Header Jumper pins 1-2 to enable Bank A Flash Write
No jumper to disable Flash Writes
SW2 Manual Geographic
Address - OFF (default) - GA from CompactPCI backplane
ON - generate address locally
Damage of the Product
Setting/resetting the switches during operation can cause damage of the product.
Check and change switch settings before you install the product.