Motorola CPCI-6115 - Manual (Page 43)

J25, SROM Initialization Enable Header Hardware Preparation and Installation
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D) 41
2.5.8 J25, SROM Initialization Enable Header
A 3-pin header is used to enable or disable the SROM initialization. A jumper placed between
pins 1 and 2 enables the device initialization via the I
2 C SROM. No jumper or a jumper placed
between pins 2 and 3 disables the initialization sequence.
2.5.9 J99, Flash Bank A Programming Enable Header
To protect the contents of Flash Bank A a 2-pin header is used to enable or disable the
programming of Flash Bank A. A jumper across pins 1 and 2 enables writes to array blocks,
programming data, or configuring lock-bits. No jumper installed disables all Flash Bank A
programming.
Figure 2-9 Jumper Setting for J25
Figure 2-10 Jumper Setting for J99