Motorola CPCI-6115 - Manual (Page 94)

CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
Transition Module Preparation and Installation Rear Panel Connectors
92
5.4 Rear Panel Connectors
The rear panel port connectors on the CPCI-6115-MCPTM are listed in Table 5-1 and shown in
Figure 5-2 on page 91 . Refer to Table 5-10 on page 100 for connector pinout information.
5.5 On-Board Connectors and Headers
The following table lists the connectors and headers on the CPCI-6115-MCPTM. Use the links
in the Location column to find the connector descriptions and pin assignments or jumper
settings.
Table 5-1 CPCI-6115-MCPTM Rear Panel Connectors
Type Number Description
Serial Ports J25 Routed to four RJ-45 connectors for COM1, COM2, COM3,
and COM4 connections (MXP version). Note: COM3 and
COM4 are not used.
Table 5-2 On-Board Connectors and Headers
Connector/Header Location
CPCI-6115-MCPTM IDE CompactFlash Connector (J1) Table 5-3 on page 93
CPCI-6115-MCPTM PMC I/O Module 1 - Host I/O Connector (J10) Table 5-4 on page 94
CPCI-6115-MCPTM PMC I/O Module 2 - Host I/O Connector (J20) Table 5-5 on page 95
CPCI-6115-MCPTM PMC I/O Modules 1 & 2 - PMC I/O (J14/J24) Table 5-6 on page 96
CPCI-6115-MCPTM CompactPCI User I/O Connector (J3) Table 5-7 on page 97
CPCI-6115-MCPTM CompactPCI User I/O Connector (J5) Table 5-8 on page 98
CPCI-6115-MCPTM 10/100/1000BaseTx Connectors Table 5-9 on page 100
COM1 Header (J6) COM1 and COM2
Asynchronous Serial
Ports Jumpers
on page
102
COM2 Header (J11) COM1 and COM2
Asynchronous Serial
Ports Jumpers
on page
102
CompactFlash Selection Header (J2) CompactFlash Jumper
on page 102