Motorola CPCI-6115 - Manual (Page 55)

J95, Front Panel 10/100/1000 Megabits/s Ethernet Connector Controls, LEDs, and Connectors
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D) 53
3.5.2 J95, Front Panel 10/100/1000 Megabits/s Ethernet Connector
The CPCI-6115 has one front panel 10/100/1000 megabit/s Gigabit Ethernet connector. It is an
industry standard RJ-45 connector with the following pin assignments:
3.5.3 CompactPCI J1/J2 Connectors
The CPCI-6115 CPU board implements a 64-bit CompactPCI interface on connectors J1 and
J2. J1 is a 110 pin AMP Z-pack 2mm hard metric type A connector with either +3.3 V or +5 V
signaling. J2 is a 110 pin AMP Z-pack 2mm hard metric type B connector. Each of these
connectors conform to the CompactPCI specification. The pinout for connectors J1 and J2 are
implemented as defined in the CompactPCI specification for a 64-bit peripheral slot board. Note
that no reserved or bussed reserved pins are used by CPCI-6115.
2 RTS OUTPUT
3 GNDC N/A
4 TXD OUTPUT
5 RXD INPUT
6 GNDC N/A
7 CTS INPUT
8 DTR OUTPUT
Table 3-2 COM1 Pin Assignments, J19 (continued)
Pin # Signal Direction
Table 3-3 10/100/1000 Megabit/s Ethernet Connector, J95
Pin # 1000 Megabit/S 10/100 Megabit/S
1 MDIO0+ TD+
2 MDIO0- TD-
3 MDIO1+ RD+
4 MDIO2+ Not Used
5 MDIO2- Not Used
6 MDIO1- RD-
7 MDIO3+ Not Used
MDIO3- 8 Not Used