Motorola CPCI-6115 - Manual (Page 57)

CompactPCI User I/O Connector Controls, LEDs, and Connectors
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D) 55
3.5.6 CompactPCI User I/O Connector
Connector J3 is a 110 pin AMP Z-pack 2mm hard metric type B connector. This connector
routes the I/O signals for one of the PMC slots and two 10/100/1000Base-T Ethernet channels
compliant with the CompactPCI Packet Switching Backplane Specification. The pin
assignments for J3 are as follows:
(Note that outer row F is assigned and used as ground pins but is not shown in the table).
19 GND GND RSV RSV RSV
18 BRSVP2A18 BRSVP2B18 BRSVP2C18 GND BRSVP2E18
17 BRSVP2A17 GND RSV RSV RSV
16 BRSVP2A16 BRSVP2B16 RSV GND BRSVP2E16
15 BRSVP2A15 GND RSV RSV RSV
14 AD[35] AD[34] AD[33] GND AD[32]
13 AD[38] GND V(IO) AD[37] AD[36]
12 AD[42] AD[41] AD[40] GND AD[39]
11 AD[45] GND V(IO) AD[44] AD[43]
10 AD[49] AD[48] AD[47] GND AD[46]
9 AD[52] GND V(IO) AD[51] AD[50]
8 AD[56] AD[55] AD[54] GND AD[53]
7 AD[59] GND V(IO) AD[58] AD[57]
6 AD[63] AD[62] AD[61] GND AD[60]
5 C/BE[5]# 64EN# V(IO) C/BE[4]# PAR64
4 V(IO) BRSVP2B4 C/BE[7]# GND C/BE[6]#
3 RSV GND RSV RSV RSV
2 RSV RSV SYSEN#
a
RSV RSV
1 RSV GND RSV RSV RSV
a. Defined as SYSEN#. This OV allows the CPCI-6115 to ensure that it is installed into a peripheral slot.
Table 3-5 CompactPCI Connector, J2 (continued)
Pin Row A Row B Row C Row D Row E
Table 3-6 User I/O Connector Pinout, J3
Pin Row A Row B Row C Row D Row E Pin
19 GND +12 V -12 V GND GND 19
18 LPa_DA+ (TX1+) LPa_DA- (TX1-) GND LPa_DC+ LPa_DC- 18
17 LPa_DB+ (RX1+) LPa_DB- (RX1-) GND LPa_DD+ LPa_DD- 17
16 LPb_DA+ (TX2+) LPb_DA- (TX1-) GND LPb_DC+ LPb_DC- 16
15 LPb_DB+ (RX2+) LPb_DB- (RX2-) GND LPb_DD+ LPb_DD- 15