1 installing pmc modules on the cpci-6115, Installing pmc modules on the cpci-6115 – Motorola CPCI-6115 User Manual
Page 45
Installing PMC Modules on the CPCI-6115
Hardware Preparation and Installation
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
43
When it is determined that there are no bent pins on the board connectors or backplane,
carefully slide the board into the backplane slots until the board ejector handles come in contact
with the system chassis. Do not force the board into the backplane slot. As the handles
engage, apply forward pressure while pushing the ejector handles toward each other. Pushing
the handles towards each other seats the board into the backplane.
In most cases, PMC modules ordered with the baseboard are installed on the CPCI-6115 at the
factory and the order is shipped as a single unit. The user-configured jumpers on the PMCs are
accessible with the modules installed.
If you need to install PMCs on the baseboard, refer to
Installing PMC Modules on the CPCI-
for the installation procedure. The procedure assumes the CPCI-6115 has
already been installed in the chassis.
2.7.1
Installing PMC Modules on the CPCI-6115
One dual-wide, one single-wide or two single-wide PCI mezzanine (PMC) modules can be
mounted on the CPCI-6115 baseboard. Each PMC slot has four connectors that provide a PCI
interface to two PMC slots that provide a user I/O to the backplane. Refer to
for the total current available to PMCs and transition module.
Procedure
To install a PMC module follow these steps.
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten their life.
Before touching the AMC or electronic components, make sure that you are working
in an ESD-safe environment.
Product Damage
Inserting or removing modules in a non-hot-swap chassis with power applied may
result in damage to module components. The CPCI-6115 is a hot-swappable board
and may be inserted in a hot-swap chassis, such as a CPX2000, CPX8000 or MXP3000
series chassis with power applied.
Check to make sure your chassis is hot swap compliant.