FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 480)

showntp(8)
456 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised November 2009
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
■ When the preferred server not designated, the NTP server in the output of the
showntp
(8) command does not come with the prefer information.
■ The setntp(8) command sets the NTP servers used in the XSCF network.
■ When you use the showntp(8) command after the setntp(8) command, it will
display the pending modifications performed by setntp(8), which might not yet
be effective. If not yet effective, the setting will not match the actual NTP settings
currently in operation. To view the NTP settings currently in operation, execute
showntp
(8) command with the -l option.
EXAMPLES EXAMPLE 1 Displays all NTP servers currently being set (in a case that the preferred serv-
er designated).
EXAMPLE 2 Confirms synchronization with an NTP server and displays the results.
address Specifies the IP address or the XSCF host name of an NTP server
to be displayed. If the -a option is specified, the operand is
ignored.
A specified IP address is a set of four integer values delimited by
the "." (period). The following address form is accepted:
xxx.xxx.xxx.xxx
where:
xxx An integer from 0–255. Zero suppression can
be used to specify the integer.
The host name can be specified in the format that complies with
RFC 1034.
XSCF> showntp -a
server ntp1.example.com prefer
server ntp2.example.com
XSCF> showntp -l
remote refid st t when poll reach delay offset jitter
========================================================================
*192.168.0.27 192.168.1.56 2 u 27 64 377 12.929 -2.756 1.993
+192.168.0.57 192.168.1.86 2 u 32 64 377 13.030 2.184 94.421
127.127.1.0 .LOCL. 5 l 44 64 377 0.000 0.000 0.008