FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 381)

showdateoffset(8)
System Administration 357
NAME showdateoffset - display differences between system time and domain times
SYNOPSIS showdateoffset -d domain_id
showdateoffset -a
showdateoffset -h
DESCRIPTION The showdateoffset(8) command displays the differences in seconds between the
time of the system, managed by the XSCF clock, and the time of the domains, each
of which is managed by its domain clock.
If you change the time setting on a domain, for example by using the date(1M)
command, the time of that domain differs from the time of the system. The
difference between the revised time of the domain and the time of the system is
stored on the XSCF, and is retained after domain reboot and after XSCF reset.
Privileges You must have one of the following privileges to run this command:
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXAMPLES EXAMPLE 1 On the M3000 server, displays the time differences between the time of the
system and the time of the domains with specifying the ID of the domain.
useradm , platadm, platop, fieldeng
Can run this command for all domains.
domainadm , domainmgr, domainop
Can run this command only for your accessible domains.
-a Displays the time differences between the time of the system and
the time of all accessible domains.
-d domain_id Specifies only one ID of the domain on which the time
differences is displayed. domain_id can be 0–23 depending on the
system configuration.
-h Displays usage statement. When used with other options or
operands, an error occurs.
XSCF> showdateoffset
DID Domain Date Offset
00 128 sec