FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 337)

setupplatform(8)
System Administration 313
NAME setupplatform - set up platform specific settings
SYNOPSIS setupplatform [-v]
setupplatform [-v] -p part [-p part]
setupplatform -h
DESCRIPTION The setupplatform(8) command sets up platform specific settings. The command
leads an administrator through Service Processor installation tasks.
By default, setupplatform command walks through each of the available
settings. Individual settings may be selected using the -p option.
Privileges You must have one of the following privileges to run this command:
■ To use the -p user option: usradm
■ To use the -p network, -p altitude, -p timezone options: platadm
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
The available interfaces on the M3000/M4000/M5000 servers are xscf#0-lan#0,
xscf#0-lan#1, lan#0, lan#1. The available interfaces on the M8000/M9000 servers are
the same but they also include the xscf#0-if, xscf#1-lan#0, xscf#1-lan#1, and xscf#1-
if.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-p part Specifies the setting you want to do. One of the following can be
specified for part:
altitude Configures the chassis altitude.
network Configures the XSCF network, DSCP, DNS,
NTP, SSH, https, and SMTP.
timezone Sets the time zone for the XSCF. The time
zone is chosen from a list of time zones.
user Creates a new local XSCF user account with
platadm, platop, and useradm privileges.
Note that an XSCF user account user name
cannot match an LDAP user name, and an
XSCF user account (UID) number cannot
match an LDAP UID number.
-v Specifies verbose output.