FUJITSU SPARC ENTERPRISE M9000 User Manual
Page 372
showcodusage(8)
348
SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised July 2010
EXTENDED
DESCRIPTION
The showcodusage -p resource command displays the following COD usage
information for the system:
The showcodusage -p domain command displays the following COD usage
information for each domain:
Resource
Identifies the type of COD resources available (processors).
In Use
Specifies the number of COD CPUs currently used in the
system.
Installed
Specifies the number of COD CPUs installed in the system.
COD Permitted
Specifies the number of COD permits installed.
Status
Specifies one of the following COD attributes:
OK
Indicates that there are sufficient permits
for the COD CPUs in use. Also displays
the number of remaining COD resources
available and the number of any instant
access CPUs (headroom) available.
HEADROOM
The number of instant access COD CPUs
in use.
Violation
Indicates a COD permit violation exists.
Displays the number of COD CPUs in use
that exceeds the number of COD permits
available. This situation can occur when
you force the deletion of a COD key from
the COD Hardware Activation database,
but the COD CPU associated with the key
is still in use.
Domain/Resource
Identifies COD resource (processor) for each domain. An
Unused processor is a COD CPU that has not yet been
assigned to a domain.
In Use
Specifies the number of COD CPUs currently used in the
domain.