FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 285)

setpowerupdelay(8)
System Administration 261
NAME setpowerupdelay - set the warm-up time of the system and wait time before system
startup
SYNOPSIS setpowerupdelay -c warmup -s time
setpowerupdelay -c wait -s time
setpowerupdelay -h
DESCRIPTION The setpowerupdelay(8) command sets the warm-up time of the system and wait
time before system startup.
The wait time before system startup can be used to control the system startup time
so that the system is started only after air-conditioning makes the temperature of
the computer room suitable. If the system power has already been turned on and
the system is operating, the setting takes effect at the next startup.
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
■ You can use the showpowerupdelay(8) command to check the warm-up time
and the wait time before system startup, previously set by the
setpowerupdelay
(8) command, regardless of whether the system is in
operation.
■ When the power is turned on from the operator panel, the wait time and warm-
up time that you set are ignored. If you have set these times and wish to observe
them at startup, perform the poweron(8) command.
EXAMPLES EXAMPLE 1 Sets the warm-up time to 10 minutes.
-c warmup Specifies the warm-up time.
-c wait Specifies the wait time before system startup.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-s time Specifies the warm-up time or wait time before system startup in
minutes. An integer ranging from 0 to 255 can be specified for
time.
XSCF> setpowerupdelay -c warmup -s 10