FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 407)

showdualpowerfeed(8)
System Administration 383
NAME showdualpowerfeed - display the current setting of dual power feed mode
SYNOPSIS showdualpowerfeed
showdualpowerfeed -h
DESCRIPTION The showdualpowerfeed(8) command displays the current setting of dual power
feed mode in the system.
Note – The ability to display the current status of the dual power feed is available
on M3000/M4000/M5000 servers only. However, the dual power feed mode cannot
be used with 100V power on M4000/M5000 servers. When the optional power
cabinet for dual power feed is connected on M8000/M9000 servers, it automatically
configures the dual power feed mode. For details about the setting the dual power
feed, see the Installation Guide for your server.
The dual power feed mode can be set by the setdualpowerfeed(8) command.
Also, before the dual power feed mode is changed by the setdualpowerfeed(8)
command, the values of changed settings are displayed.
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXAMPLES EXAMPLE 1 Displays the current setting of dual power feed mode in the system.
EXAMPLE 2 Changes the dual power feed mode with the setdualpowerfeed(8) com-
mand and then displays the current state.
EXIT STATUS The following exit values are returned:
-h Displays usage statement.
XSCF> showdualpowerfeed
Dual power feed is enabled.
XSCF> showdualpowerfeed
enable -> disable
NOTE: Dual power feed will be disabled the next time the platform is powered
on.
0 Successful completion.
>0 An error occurred.