FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 225)

setdualpowerfeed(8)
System Administration 201
NAME setdualpowerfeed - set dual power feed mode
SYNOPSIS setdualpowerfeed -s key
setdualpowerfeed -h
DESCRIPTION The setdualpowerfeed(8) command specifies dual power feed mode in the
system.
Note – The ability to enable and disable dual power feed is available on M3000/
M4000/M5000 servers only. However, dual power feed mode cannot be used with
100V power on M4000/M5000 servers. When the optional power cabinet for dual
power feed is connected on M8000/M9000 servers, it automatically configures dual
power feed mode. For details about the setting of dual power feed, see the
Installation Guide for your server.
To enable the dual power feed mode, you need to execute the rebootxscf(8)
command or turn off and on the input power.
To disable the dual power feed mode, you need to turn off and on the input power.
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
The state of the current dual power feed mode can be checked by using the
showdualpowerfeed
(8) command.
EXAMPLES EXAMPLE 1 Disables dual power feed mode in the system. Before rebooting the system, a
message is displayed.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-s key Sets dual power feed mode in the system. Either of the following
can be specified for key:
enable Enables the dual power feed mode.
disable Disables dual power feed mode.
XSCF> setdualpowerfeed -s disable
enable -> disable
NOTE: Dual power feed will be disabled the next time the platform is powered
on.