FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 445)

showlocator(8)
System Administration 421
NAME showlocator - display the state of the CHECK LED on the operator panel
SYNOPSIS showlocator
showlocator -h
DESCRIPTION showlocator (8) command displays the blink state of the CHECK LED on the
operator panel.
The one of the following state is displayed:
Privileges You must have one of the following privileges to run this command:
useradm , platadm, platop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following option is supported:
EXTENDED
DESCRIPTION
The setlocator(8) command can be used to specify the blink state of the CHECK
LED.
EXAMPLES EXAMPLE 1 Displays the CHECK LED state.
EXIT STATUS The following exit values are returned:
SEE ALSO setlocator(8)
Off Indicates normal operation, which means either the circuit
breaker is off or power is not being supplied.
Blinking Indicates that the unit is a maintenance target.
On Indicates that an error was detected in the main unit.
-h Displays usage statement.
XSCF> showlocator
Locator LED status:Blinking
0 Successful completion.
>0 An error occurred.