FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 28)

Intro(8)
4 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised July 2010
setpacketfilters set the IP packet filtering rules to be used in the XSCF
network
setpasswordpolicy manage the system password policy
setpowerupdelay set the warm-up time of the system and wait time before
system startup
setprivileges assign user privileges
setroute set routing information for an XSCF network interface
setshutdowndelay set the shutdown wait time at power interruption of the
uninterruptible power supply (UPS)
setsmtp set up the Simple Mail Transfer Protocol (SMTP) settings
setsnmp manage the SNMP agent
setsnmpusm specify the SNMPv3 agent’s User-based Security Model
(USM) configuration
setsnmpvacm modify the SNMPv3 agent’s View-based Access Control
Model (VACM) configuration
setssh configure the settings for the Secure Shell (SSH) service
used in the XSCF network
setsunmc start or stop the Sun Management Center agent and make
changes to its configuration
settelnet start or stop the telnet service used in the XSCF network
settimezone set the time zone and Daylight Saving Time of XSCF
setupfru set up device hardware
setupplatform set up platform specific settings
showad show Active Directory configuration and messages
showaltitude display the altitude of the system and whether the air filter
installed
showarchiving display log archiving configuration and status
showaudit display the current auditing system state
showautologout display the session timeout time of the XSCF shell
showboards display information on an eXtended System Board (XSB)
showcod display Capacity on Demand (COD) configuration
information
showcodactivation display the current Capacity on Demand (COD) activation
permits stored in the COD Hardware Activation database