FUJITSU SPARC ENTERPRISE M9000 - Manual (Page 275)

setpacketfilters(8)
System Administration 251
NAME setpacketfilters - set the IP packet filtering rules to be used in the XSCF network
SYNOPSIS setpacketfilters [ [-q] -{y|n}] -c {add | del} [-i interface] [-s address [ /mask]]
-j target
setpacketfilters [ [-q] -{y|n}] -c clear
setpacketfilters -h
DESCRIPTION The setpacketfilters(8) command sets the IP packet filtering rules to be used
in the XSCF network.
IP packet filtering rules can be used to prevent illegal access to the XSCF network.
Settings specified with setpacketfilters(8) are applied immediately after the
command is executed.
Privileges You must have platadm or fieldeng privilege to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-c
{add|del|clear}
Specifies the operation to define the IP packet filtering rule.
Any of the following can be specified. This option cannot be
omitted.
add Adds an IP packet filtering rule.
del Deletes specified IP packet filtering rule.
clear Clears all IP packet filtering rules which
have been set.
-h Displays usage statement. When used with other options or
operands, an error occurs.