FUJITSU PRIMERGY BX400 S1 - Manual (Page 32)

32 Operating Manual BX400 S1
Important notes
©
c
o gni
ta
s.
Ge
se
lls
ch
ft f
ür T
ec
hn
ik
-Do
ku
m
ent
at
io
n m
b H 20
12
P
fa
d:
C
:\P
rogr
am
m
e \F
CT
\t im
_ap
p\
tim
_l
oc
al
\w
ork
\W
A
LT
E
R
\O
B
J_
DO
K U
-9
24
4-0
04
.fm
Before starting up
V
CAUTION!
● During installation and before operating the device, observe the
instructions on environmental conditions for your device (see
"Ambient conditions" on page 27 ).
● If the system unit has been moved from a cold environment,
condensation may form both inside and on the outside of the
machine.
Wait until the system unit has acclimatized to room temperature and
is absolutely dry before starting it up. Material damage may be
caused to the system unit if this requirement is not met.
● Only transport the system unit in the original packaging or in
packaging that protects it from impacts and jolts.
For the Japanese market, transporting the device in its original
packaging does not apply.
Installation and operation
V
CAUTION!
● The device may only be operated in a maximum ambient temperature
of 35 °C.
● If the device is integrated in an installation that receives power from
an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type B connector.
●
The device automatically adjusts to a mains voltage in the range of
100 - 120 V / 200 - 240 V. Make sure that the local mains voltage is
neither above nor below these limits.
● This device must only be connected to properly grounded power
outlets or to the insulated sockets of the rack's internal power supply
using safety-tested power cables.
● Make sure that the device is connected to a protective contact socket
that is close by the device.