FUJITSU DL3800 User Manual
Page 97
Setup Mode
USING SETUP MODE
User's Manual
5-9
Points to Remember
• Load continuous forms paper before entering setup mode. In
setup mode, the LF/FF button cannot be used to feed paper.
To adjust the line position of paper in setup mode, use the
platen knob.
• Whenever you enter setup mode, short help menus are printed
at the top of the page. Help menus are also printed when you
select the SELF-TST, HEX-DUMP, or V-ALMNT functions.
Use help menus for quick reference while in setup mode.
• When printing the items and options for each function, you
can only print one item at a time. However, you can move
either forward or backward in the item list. To move forward
(print the next item), press the FONT button. To move
backward (print the previous item), press the MENU button.
• While in the <
function that contains items and selectable options, press the
ONLINE button to reprint the <
• A short underline under the first two letters of an option
indicates that it is the current default setting. For example, 12
CPI indicates that 12 characters per inch is the default pitch.
To change the default, select and save a new pitch setting.
• While in setup mode, you can use the LIST function to print
out a list of the currently selected options (see the next section
for details).
• To exit setup mode and permanently save your changes, select
either the SAVE & END function. For details, see the section
Exiting and Saving
later in this chapter. To exit setup mode
without saving your changes, turn the printer off. Your
previous power-on defaults are active when you turn the
printer on again.
#05 Chapter 5
2000.09.20, 2:36 PM
9