FUJITSU DL3800 User Manual

Page 115

Setup Mode

USING SETUP MODE

User's Manual

5-27

3. Select an emulation.

Repeatedly press the LOCK button to position the cursor

under the emulation you require. Then do either of the
following:

• Press the FONT button to select the emulation and print the

next MENU1 or MENU2 item. (As shown in Table 5.3, this
is the item).

• Press the MENU button to select the emulation and print

<==END==>. Press the MENU button again to print the
last MENU1 or MENU2 item. (As shown in Table 5.3, this is
the item). The MENU button is convenient
when the options you need to change are near the end of the
list of items.

Procedure

To change the options assigned to MENU1 or MENU2, make sure that
continuous forms paper is loaded and then proceed as follows:

1. Enter setup mode.

Press the FONT button and the MENU button simultaneously

until the printer beeps. Wait for the printer to stop printing.
The following <> menu is printed:

SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP

V-ALMNT

2. Select the MENU1 or MENU2 function.

Repeatedly press the LOCK button to position the red cursor

under either the MENU1 or MENU2 function. Press the FONT
button or the MENU button to select the function and print the
following options:

DPL24C+ XL24E ESC/P2

#05 Chapter 5

2000.09.20, 2:36 PM