FUJITSU DL3800 - Manual (Page 123)

Setup Mode
USING SETUP MODE
User's Manual 5-35
Table 5.5 ADJUST Items and Options
NOTE: Underlined options are the factory defaults.
Sets the top-of-form for continu-
ous forms in increments of 1/6
inch (4.2␣ mm) from the physical
top of the page.
1/6 IN The default is recommended if
: your top margin is not software-
6/6 IN specified. A setting of 1/6 inch
: is preferable when your top
66/6 IN margin is software-specified.
Fine-tunes the top-of-form
position for continuous forms.
0/180, ..., 29/180 Increases top-of-form in
increments of 1/180 inch
(0.14 mm).
Sets the top-of-form for single
sheets in increments of 1/6 inch
(4.2 mm) from the physical top
of the page.
1/6 IN The default is recommended if
: your top margin is not software-
6/6 IN specified. A setting of 1/6 inch
: is preferable when your top
66/6 IN margin is software-specified.
Fine-tunes the top-of-form
position for single sheets.
0/180, ..., 29/180 Increases top-of-form in
increments of 1/180 inch
(0.14␣ mm).
ADJUST
Items
Options Description
#05 Chapter 5 2000.09.20, 2:37 PM 35