FUJITSU DL3800 - Manual (Page 53)

User's Manual
Paper
Handling
PAPER HANDLING
3-3
Lever/Button Purpose Action
LF/FF Form feed Press and hold LF/FF to execute a form
feed. Continuous forms are fed forward
by one page. Single sheets are ejected.
Line feed Press LF/FF within three seconds to feed
paper forward by one line.
Forward micro Press LF/FF and ONLINE to feed paper
feed
forward by 1/180 inch.
TEAR OFF Advance forms Press TEAR OFF to advance the forms
for tear-off
perforation to the tear-off edge. Tear off
the forms, then press any button to
retract remaining the forms.
Reverse micro Press TEAR OFF and ONLINE to feed
feed paper backward by 1/180 inch.
LOAD Load/unload Press LOAD to load paper or to retract
paper continuous forms to the "park position."
Save adjusted Press LOAD and ONLINE to perma-
load point nently store the load position adjusted by
micro feeding.
Paper Select paper Move the paper select lever forward for
select path single sheets (cut sheet stand or feeder).
lever * Move the paper select lever backward for
continuous forms.
Paper Adjust for Select the number corresponding to the
thickness paper thickness number of copies (including the original).
lever or number of Vary the setting up or down (including A
copies to D ) to optimize printing. Select D when
replacing ribbon or clearing a paper jam.
* The following graphics are engraved on the cover.
: Continuous forms
: Cut sheets
Table 3.1 Levers and Buttons Used for Paper Handling
#03 Chapter 3 2000.09.20, 2:32 PM 3