FUJITSU DL3800 - Manual (Page 100)

USING SETUP MODE
User's Manual 5-12
MENU1 EMULATE The emulation selected on the printer
must be the same as the emulation
selected in your software. If you selected
an emulation when you set up the
printer (Chapter 2), you do not need to
change the EMULATE option unless you
want to change to a different emulation.
The emulation assigned to MENU1 is the
default when you turn the printer on.
See the section Changing MENU1 and
MENU2 Options
later in this chapter.
MENU2 None If you use MENU2, the emulation selected
for MENU 2 must be the same as the
emulation selected in your software.
See the section Changing MENU1 and
MENU2 Options
later in this chapter.
DECIDING WHICH OPTIONS
TO CHANGE The previous page shows a printout of the printer’s factory default
settings. In this printout, options are listed by functional group:
• Menu 1 settings (MENU1 function)
• Menu 2 settings (MENU2 function)
• Hardware settings (HARDWRE function)
• Print position adjustment settings (ADJUST function)
• Configuration settings (CONFIG function)
Most selectable options only alter print features, such as the
typestyle, page format, and color selection. However, some options
must be selected correctly for the printer to work properly with
your hardware and software. For each function, Table 5.2 lists items
whose options must be selected correctly for system and printer
accessory compatibility.
Table 5.2 Required Options
Function Item Option
#05 Chapter 5 2000.09.20, 2:36 PM 12