FUJITSU DL3800 User Manual
Page 116
USING SETUP MODE
User's Manual
5-28
NOTE
Whenever you select a new emulation, all MENU1 or
MENU2 options are reset to the factory defaults for that
emulation.
4. If necessary, change the other MENU1 or MENU2 options.
Press the LOCK button to move the cursor to the option you
want to select. Press the FONT button to select the option and
print the next item listed in Table 5.3. Press the MENU button
to select the option and print the previous item.
5. Exit MENU1 or MENU2.
Press the ONLINE button to exit the selected function and
reprint the <
6. Do either of the following:
• Select another function, or
• Exit setup mode, saving your changes.
For details about other functions, see the other sections in this
chapter. To exit setup mode and save your changes, make sure
the red cursor is positioned beneath SAVE & END, and then
press the FONT button or the MENU button.
Resetting MENU1 and MENU2
To reset the factory defaults for both MENU1 and MENU2, select the
DEFAULT function. For more information, see the section Resetting
Defaults
later in this chapter. The DEFAULT function cannot reset
those options which are handled by the HARDWRE, ADJUST, and
CONFIG functions.
#05 Chapter 5
2000.09.20, 2:36 PM
28