FUJITSU DL3800 - Manual (Page 72)

PAPER HANDLING
User's Manual 3-22
Unloading Continuous Forms
NOTE
Continuous forms paper that is fed by the pull-tractor cannot
be unloaded.
To unload continuous forms:
1. Make sure that the paper select lever is set to the rear position.
2. Press the LOAD button. The continuous forms paper is
retracted to the park position. If the paper cannot be retracted
in one operation, continue to press the LOAD button until the
paper is parked.
NOTE
The printer can retract continuous forms paper a maximum of
55.8 cm (22 inches) per operation.
3. To remove the paper, raise the tractor paper holders and lift
out the paper.
Tearing Off Continuous Forms
NOTE
Continuous forms paper that is fed by the pull-tractor cannot be
torn off in this way.
Your printer has a special “tear-off edge” that allows you to tear off
printed pages without wasting paper. The tear-off edge is located on
the separator.
To tear off continuous forms using the tear-off edge:
1. Press the TEAR OFF button. The bottom perforation of the last
page advances to the tear-off edge. If you specified TEAR OFF:
AUTO using the HARDWRE function in setup mode, the paper
automatically advances to the tear-off edge at the end of each
job (or when the printer has printed all the data received).
#03 Chapter 3 2000.09.20, 2:33 PM 22