FUJITSU DL3800 User Manual
Page 128
USING SETUP MODE
User's Manual
5-40
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options
Description
In some application programs, data
(continued)
transfer may stop temporarily due
to internal processing. This setting
can avoid an undesired tearoff feed
by waiting for up to six seconds
each time data transfer stops.
Single sheet autoloading.
AUTO
Single sheet paper is automatically
loaded a certain time after you set
the paper.
BUTTON
Single sheet paper can be loaded by
pressing the LOAD button.
The following
CUTLOAD:AUTO is specified for the
Autoload start time.
0.5, 1.0,
Autoloading starts when this
1.5, 2.0
amount of time passes after you set
2.5, 3.0SEC
single sheet paper.
Command decode timing.
DIRECT
The printer decodes certain com-
mands immediately after receiving
data.
Example:
ESC SUB I, ESC CR P (DPL24C+)
ESC Q # (IBM XL24E)
QUEUED
The printer decodes commands after
storing all data (including com-
mands) in the input buffer. This
speeds data reception because the
printer does not require decoding
time during data reception.
#05 Chapter 5
2000.09.20, 2:37 PM
40