FUJITSU DL3800 - Manual (Page 101)

Setup Mode
USING SETUP MODE
User's Manual 5-13
Table 5.2 Required Options (Cont.)
HARDWRE FORMAT If you have a serial interface, the serial
BAUD-RT interface options selected on the printer
PROTOCL must be the same as the settings you
DSR selected using your software or your
DUPLEX computer operating system. If the settings
are not the same, the printer will not
print or will print garbage.
See the section Changing Hardware
Options
later in this chapter.
ADJUST None If you are not using software to specify
the top margin of the page, use the
printer’s default top-of-form setting,
1 inch (25.4 mm) from the top of the
paper. If you are using software to
specify the top margin of the page,
change the default setting to 1/6 inch
(4.2 mm).
See the section Changing Print Position
Adjustment Options
later in this
chapter.
CONFIG None If you are using paper that is dark-
colored or preprinted with dark colors,
you may need to disable the AREA
OVER detection function.
See the section Changing Configuration
Options
later in this chapter.
Function Item Option
#05 Chapter 5 2000.09.20, 2:36 PM 13