FUJITSU DL3800 User Manual
Page 134
USING SETUP MODE
User's Manual
5-46
<
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
1. Enter setup mode.
Press the FONT button and the MENU button simultaneously
until the printer beeps. Wait for the printer to stop printing
and check that the following <
2. Select the DEFAULT function.
Repeatedly press the LOCK button to position the red cursor
under DEFAULT. Press the FONT button or the MENU button
to select the DEFAULT function. The printer reprints the
<
MENU2 are now reset.
3. Do either of the following:
• Select new options for MENU1 or MENU2.
• Exit setup mode, saving the factory defaults.
See the section Changing MENU1 and MENU2 Options. To
exit setup mode and save the new defaults, make sure that the
red cursor is positioned under SAVE & END, then press the
FONT button or the MENU button.
This section describes how to use the following diagnostic functions:
• SELF-TST
• HEX-DUMP
• V-ALMNT
These functions are used for checking print quality and diagnosing
printer problems. HEX-DUMP also provides useful information for
programmers.
USING THE DIAGNOSTIC
FUNCTIONS
#05 Chapter 5
2000.09.20, 2:37 PM
46