FUJITSU DL3800 User Manual

Page 60

Text mode
Original mode

PAPER HANDLING

User's Manual

3-10

Adjusting the left margin

To help align the left paper guide, use the inch-based ruler located
behind the paper guides. The ruler is graduated in 10 columns per
inch. For example, setting the left paper guide 12.7 mm (0.5 inch) from
the left gives a left margin of 6.3 mm (0.25 inch) plus the left margin
specified by your software or the printer setup mode.
The following figure is for ASF300-type cut sheet feeder.

• Slide the right paper guide until the distance between the two

guides is the approximate width of your paper.

5. Manually fan the stack of paper and place it in the paper bin.

NOTE
A short vertical mark inside each paper guide indicates the
maximum capacity of the bin. Make sure that your paper
stack does not cover these vertical marks.

Make sure that the left edge of
your paper falls within this area.

#03 Chapter 3

2000.09.20, 2:33 PM