Midi & wifi connectivity – Torso Electronics T-1 16-Track Algorithmic Desktop Sequencer User Manual
Page 172
172
The T-1 Notebook : Reference & Guide
NOTES
▌ MANUAL PER STEP SEQUENCING - CC PARAMETERS
1. Set a Track to CC Mode by pressing [CTRL] + [VBx] to cycle through
the track modes. A CC Track will illuminate CYAN
⬛
.
2. Switch to CC Sequencing mode. Double tap [VBx] where ‘x’ is the value
button representing the CC track to edit.
3. The value buttons will be shown as per the current track sequence.
Pulses will be shown on steps if they exist.
4. To enter Per Step edit mode, Press [VBx] for the step to edit. A step
does not necessarily need a pulse.
5. The selected step will flash to indicate the step is selected for editing.
The [BANK] button will flash RED
⬛
to indicate that per step edit mode
is active.
6. If required multiple steps can be selected to edit together.
Hold [VBx] + [VBx] simultaneously, where ‘x’ represents each step to
select for editing.
7. To edit the selected, flashing pulse, Turn the (Knob) for one or more CC
parameter values to adjust. Each knob should have an assigned CC
value. The parameter change is locked to the step and will illuminate
CYAN
⬛
to indicate one or more parameters are locked to the step.
8. To clear CC step edits manually, Hold [CLEAR] + [VBx] where ‘x’ is the
value button representing the step to clear. This will remove only the CC
parameter values. Note track step edits will remain in tact.
9. Press [BANK] to exit per step edit mode. Outside of per-step editing
mode, parameters are changed globally on all steps.
.
MIDI & WiFi Connectivity
8