High End Systems High End LCD Controller for Studio Color - Manual (Page 184)

7-22 IBM-Compatible Studio Color LCD Controller
3. First, select the drive where the backup file is located. The
current drive is displayed at the top of the menu (by default,
C:\). Use the options shown in Step 2 to change the drive, if
necessary.
4. Now select a directory on the drive you selected in the
previous step. Use the options shown in Step 2 to change the
directory, if necessary.
5. Once you have selected a drive and directory, all files in the
directory are displayed. Use the
and arrow keys
to select the file to restore (upload) and press .
6. Press and hold the key (about 10 seconds) on the
controller’s front panel until the LCD display shows the
following message:
7. The Lightwave Research Backup menu should now display
an identical message.
• If so, press Y on your computer’s keyboard.
• If not, you have not selected a file to restore from.
Repeat the previous steps.
8. The menu displays a message confirming which drive,
directory and file you will back up to.
• If the displayed information is correct, press your
computer’s
key to begin the upload.
• If the displayed information is incorrect, press and
start the procedure over.
Note To stop the transfer at any time, press the key
on your computer’s keyboard, then press the key on the controller’s front panel. No data
corruption will result; stopping the transfer only limits
the amount of data you upload. )(;$2$
;()!D<;0:D Pages: 1 … 182 183 184 185 186 … 272 wrong Brand wrong Model non readable See also other documents in the category High End Systems Acoustics: AF1000 (48 pages) Sitemap
key on the controller’s front panel. No data
corruption will result; stopping the transfer only limits
the amount of data you upload.
)(;$2$
;()!D<;0:D