HP E1418A - Manual (Page 44)

/* Decode the second integer */
result = config [1]; /* Terminal Module */
if (result > 0)
{
printf (“Module does NOT have a terminal module installed\n”);
}
else
{
printf (“Module has a screw-type terminal module installed\n”);
}
/* Decode the third integer */
result=config[2]; /* Isolated or non-isolated outputs */
if (num_chan < 9) result = result << 8; /* strip upper 8 bits */
for (i=num_chan;i>0;i – –)
{
if (result >= 0x8000)
{
printf (“Channel %d is configured for non-isolated output\n”,i);
}
else
{
printf(“Channel %d is configured for isolated output\n”,i);
}
result = result << 1;
}
/* Decode the fourth integer */
result=config[3]; /* Output Mode Voltage or Current */
if (num_chan < 9) result = result << 8; /* strip upper 8 bits */
for (i=num_chan;i>0;i – –)
{
if (result >= 0x8000)
{
printf (“Channel %d is set to voltage output mode\n”,i);
}
else
{
printf(“Channel %d is set to current output mode\n”,i);
}
result = result << 1;
}
Chapter 2 Programming Examples 43
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com