HP E1418A - Manual (Page 22)

To Remove a Module: To remove a module from a mainframe:
1. Remove any terminal modules.
2. Loosen the top and bottom screws securing the module in the
mainframe.
3. Move the extraction levers away from each other. As the levers are
moved, the module will detach from the backplane connectors.
4. Slide the module out.
Note The extraction levers will not seat and unseat the backplane connectors on
older HP VXIbus mainframes and non-HP mainframes. You must
manually seat the connectors by pushing the module into the mainframe
until the front panel is flush with the front of the mainframe. The extraction
levers may be used to guide or remove the module.
Chapter 1 Module Setup and Installation 21
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com