HP E1418A - Manual (Page 37)

Using the CAL
Output Terminals
The CAL Output Terminals provide one set of connections that can be used
to calibrate the output on all 16 channels. Calibration and adjustment
procedures are described in Appendix D beginning on page 154.
The CAL output terminals are available on the terminal module. There are
four lines; HI, LO, HS (Hi Sense), and LS (Low Sense). Typical CAL
output terminal connections are shown in Figure 1-17.
Options A3E and A3H
Terminals
The CAL Output Terminals are located on the upper connector and are labeled
CAL HI, CAL HS, CAL LO, and CAL LS in the diagram on page 30.
Figure 1-17. Calbus Connections
36 Module Setup and Installation Chapter 1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com