HP E1418A - Manual (Page 30)

Extra Crimp-and-Insert
Connectors
The crimp-and-insert connector is normally supplied with Option A3E.
Contact Hewlett-Packard if additional connectors are needed.
Order HP 91484B.
Option A3H
The Ribbon Cable Connector Terminal Option provides a terminal housing
and ribbon cable connectors. The connectors are designed to be used with
64-pin 0.05 inch center ribbon cables (not provided). Use Figure 1-12 to
make the connections.
Note In Figure 1-12, the center row of each connector is not used in the ribbon
cable. The center row of both connectors is module ground (
GND ).
Option 135
The Terminal Module Housing Option provides a terminal housing with no
connectors of any type.
The user-supplied connector must be a DIN 41612 type C female,
11.6 mm dimension as shown above.
Figure 1-11. Option A3H Ribbon Cable Connector
Chapter 1 Module Setup and Installation 29
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com