HP E1418A - Manual (Page 105)

TRIGger
The TRIGger subsystem controls when and how the outputs are enabled.
Other commands, designed for use with the TRIGger subsystem are ABORt
and INITiate[:IMMediate] .
Subsystem Syntax TRIGger
[:IMMediate]
:SOURce <
source >
:SOURce?
TRIGger[:IMMediate]
TRIGger[:IMMediate] triggers all channels waiting for trigger when the trigger
source has been set to either BUS or HOLD .
Parameters None.
Comments •
To use this command to trigger outputs, the trigger source must be set to either
BUS or HOLD . An error is generated if other trigger sources are set.
•
If this command is received and the module is not in the wait-for-trigger state, an
error is generated.
•
Triggering is described in more detail on page 54.
•
Related Commands: TRIGger:SOURce ,
SOURce n :VOLTage[:LEVel][:IMMediate]:TRIGgered[:AMPLitude] ,
SOURce n :CURRent[:LEVel][:IMMediate]:TRIGgered[:AMPLitude]
TRIGger
104 HP E1418A SCPI Command Reference Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com