Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 71)

Step edit section
71
En
HARMONIZER
About the HARMONIZER
This function plays chords with the PITCH value of the parameter as
the root. When performing by tapping pads in Scale mode or operating
the pattern playback, press one of the
[HARMONIZER] buttons to play
chords with the step at the point of the pressed button as the root.
Note
Refer to “HARMONIZER settings” (page 148) to set chords for each of
the
[HARMONIZER] buttons.
Applying the HARMONIZER to a step
A chord can be set to the step parameter.
1 Set the 16-pads to Trigger mode (page 47), CV Slide mode
(page 65), or CC mode (page 61).
2 Hold down a pad of the step to be set with a chord and press one
of the [HARMONIZER] buttons.
The pressed [HARMONIZER] button lights up and the chord type of the button
is set to the step.
• To delete the chord, hold down the pad and press the same button again.