Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 52)

Step edit section
52
En
• CV Slide can be enabled only when the output terminal of a track is set to
[CV/GATE1] or [CV/GATE2] .
2 Press the16-pads to mute/unmute for each pad (step).
Repeatedly pressing the pad switches between the unmuted state (lit) of
outputting the note information set to the pad and muted state (lit dimly) of no
output.
3 Set the note information of each pad (step).
Up to 8 multiple note information can be set to each pad (step).
• When setting one note information to one pad, refer to “Setting one note
information (Monophonic note) to one pad” (page 53).
• When setting multiple note information to one pad, refer to “Setting multiple
note information (Polyphonic note) to one pad” (page 53).
4 Hold down the pad to set a parameter of each pad (step) and turn
the [COUNT/CC4] or [DIVIDE/CC5] knob.
The parameter information will be shown on the display and you can set the
corresponding parameters as follows.
• [COUNT/CC4] knob: COUNT value
• [DIVIDE/CC5] knob: DIVIDE value
Notes
• While holding down multiple pads and performing the operations above, you
can change the parameters of all the pads that are held down at the same
time.
• While not holding down any pad and performing the operations above, you
can change the parameters of all the pads in the current pattern at the same
time.